The basic operation of the laser cutting machine and the use of safety

Basic operation and safety in the use of laser cutting machines are of paramount importance, and the following is a detailed introduction to both:

Basic operation

Step 1: Preparation

1. Environment check: Make sure the environment around the laser cutting machine is clean, tidy and well ventilated.

2. Power check: check whether the power plug is well grounded to ensure safety.

3. Material preparation: Fix the material to be cut on the working platform of the laser cutting machine and make sure the positioning is accurate.

Step 2: Start the machine

1. Power on self-test: Turn on the main power switch and wait for the equipment self-test to complete.

2. Start the equipment: Press the start button on the control panel to start the laser cutting machine.

3. Check the status: Check the working status indicator to make sure the equipment works normally.

Step 3: Setting cutting parameters

1. Parameter setting: Use the control buttons to set parameters such as cutting speed, power and focal length.

2. Material Adaptation: Adjust the working parameters according to the type and thickness of the material to be cut.

Step 4: Cutting

1. Material Placement: Place the material to be cut on the working platform and adjust the position and clamping method.

2. Start cutting: Start the laser cutting machine and begin the cutting operation.

3. Observe and adjust: Observe the working status during the cutting process and adjust the parameters in time to get the best result.

Safety in use

1. Training: The operator should be professionally trained, familiar with the structure and performance of the equipment, and master the relevant knowledge of the operating system.

2. Protective wear: In the process of operation, wear labour protective equipment according to regulations, especially near the laser beam must wear protective glasses in accordance with the regulations.

3. Equipment monitoring: when the equipment is on, the operator shall not leave the post or entrust someone to take care of it without permission. If you need to leave, you should stop or cut off the power switch.

4. Abnormal processing: abnormalities found in the process, should be immediately stopped, troubleshooting or reported to the competent personnel.

In short, the basic operation of the laser cutting machine needs to be strictly observed, while ensuring the use of safety to protect the normal operation of equipment and personnel safety.